Replacing The Controllers And Wiring Harness; Removing The Controller Front Panel Bezel - Pitco SG Series Solstice Service Manual

Pitco Solstice and Solstice Supreme High Efficiency Gas Fryers
Replacing the Controllers and Wiring Harness
Removing the Controller Front Panel Bezel
1. Remove the two (2) screws on the controller
panel using a Phillips screwdriver.
2. Pull out the controller panel front bezel.
SG/SSH Series Service Manual
3. Disconnect the controller wiring harness.
4. Remove the four (4) screws on the back side of
the bezel using a 3/8 inch nut driver.
20