Siemens SIMATIC ET 200SP Manual page 59

Parameter data record
A.1 Dependencies when configuring with GSD file
Measurement Measuring
type range
Thermocou- Type B, N, E,
ple R, S, J, L, T,
K, U, C, TXK
x = property is allowed, – = property is not allowed, * = property is not relevant
Use of the "Reference channel of the module":
1
- Channel 0 must be set to "Pt100 climatic" with the temperature unit "Degrees Celsius".
- For each TC channel of this module that is intended to use channel 0 as reference, "Reference junction" must be set to
"Enable".
Use of "Reference channel of group 0":
2
- An RTD channel must be set as "Pt100 climatic" with temperature unit "Degrees Celsius".
- "Reference channel of group 0, 1, 2, 3" must be set as the "Reference junction" of this channel.
- There may be only one RTD channel with "Reference junction active" = "Enable" per group and row.
- For each TC channel of this row that is intended to use this reference, "Reference junction active" must be set to "En-
able".
Underflow = 8000 ; wire break and overflow lead to 01
3
H
therefore not relevant.
58
Temperature Slot refer-
coefficient ence junc-
tion
* Reference
channel of
the module
Internal
reference
junction
Reference
channel of
group 0, 1,
2, 3
2
Fixed refer-
ence tem-
perature
H
Analog input module AI 4xRTD/TC 2-/3-/4-wire HF (6ES7134-6JD00-0CA1)
Tempera-
ture unit
Under-
flow /
overflow
Degrees x
Celsius
1
Degrees
Fahrenheit
Kelvin
Degrees x
Celsius
Degrees
Fahrenheit
Kelvin
(triggered) → (no diagnostics), wire break and overflow are
Diagnostics
Wire Missing Refer-
break supply ence
voltage junction
L+
x x x
x x *
Manual, 09/2018, A5E03573289-AE