Setting The Mode; Types Of Mode - YOKOGAWA CA71 HANDY CAL User Manual

8.2 Setting the Mode

8.2 Setting the Mode
Step 1: Press the
Step 2: Using the pair of
Step 3: Press the
Step 4: If you set any value using the pair of
TIP
• To close the communication setting screen, press the
while simultaneously holding down the
• Even if you turn off the calibrator, the communication mode and interval
you have set are saved internally until you replace the batteries or
reconfigure the communication function.
Thus, communication will take place with the previous settings.

8.3 Types of Mode

:
: Talk-only mode – Outputs the source setpoint and measured
: Printer mode –
*: For a 0-second interval, each press of the
item. For other intervals, pressing the
communication.
8-2
key while simultaneously holding down the
key. The LCD shows
, or
key to confirm your mode selection.
If you set the mode to
When the is indicated, each press of the
outputs one data item.
shown, the calibrator outputs data using the value thus
set as the time interval (sec). The value should be set within
the range from 0 to 3600.
Normal mode –
in its upper section and either
in its lower section.
and keys, select
or
key.
Permits normal transmission and reception.
value at preset intervals (0* to 3600 sec).
Outputs the source setpoint and measured
value to a printer at preset intervals (0* to
3600 sec).
key initiates or terminates
, or
, the LCD shows
key
and keys with
key once again
key outputs one data
IM CA71-E
.
.