Maintenance; Troubleshooting - Eaton EATS16N Installation And User Manual

6.1

Troubleshooting

Operation status
Overload
Short-circuit fault
Internal relay fault
Source 1 or Source 2 power
supply fault
EEPROM fault
EATS16_EN
Possible cause
Power requirement exceeds the
ATS capacity (greater than 105 % of
nominal).
A short-circuit occurred.
Internal relay fault, note that the
load is no powered.
Internal power supply of one of the
source is faulty; the other source is
powering the load.
EEPROM fault, note that the load is
still powered.

6. Maintenance

Action
Remove some of the equipment
from the ATS.The ATS continues
to operate, but may shutdown
if the load increases.The alarm
resets when the condition becomes
inactive.
Check device connection or
integrity.
If error persists, note the alarm
message and the ATS serial
number, and then contact your
service representative.
Note the alarm message and the
ATS serial number, and then contact
your service representative.
Note the alarm message and the
ATS serial number, and then contact
your service representative.
Note the alarm message and the
ATS serial number, and then contact
your service representative.
Page 15