Cabling The Embedded Ports For Iscsi Replication; Cabling The Replication Port For Iscsi Replication - Dell SC4020 Deployment Manual

Figure 68. Wrap Label Around Cable
3. Apply a matching label to the other end of the cable.

Cabling the Embedded Ports for iSCSI Replication

If the Storage Center is licensed for replication, the management port and replication port can be
connected to an Ethernet switch and used for iSCSI replication.

Cabling the Replication Port for iSCSI Replication

If replication is licensed, the replication (REPL) port can be used to replicate data to another Storage
Center.
About this task
Connect the replication port of each storage controller to an Ethernet switch through which the Storage
Center can perform iSCSI replication.
Steps
1. Connect the replication port on storage controller 1 to Ethernet switch 2.
2. Connect the replication port on storage controller 2 to Ethernet switch 2.
NOTE: The management port on each storage controller is connected to an Ethernet switch on
the management network.
Connect the Front-End Cabling
83