Dell SC4020 Deployment Manual page 102

DNS Server 1
****************************************************************
HSN not configured.
eth0 IPv4 address not configured.
When all issues identified above are corrected, type:
'-sm -go'
to continue normal processing.
***************************************************************
4. Configure storage controller 1 with the information required to prejoin the storage controller.
a. Run the following command to set the HSN using the lower serial number provided in the pre-
installation documents.
platform init hsn set <lower HSN>
Example:
platform init hsn set 10001
b. Run the following command to specify an IP address and prefix length (subnet mask) for the
management interface (eth0).
ifconfig inet eth0 <IP address>/<prefix length>
Example:
ifconfig inet eth0 198.51.100.99/24
NOTE: Make sure to specify the prefix length in this command. If a prefix length is not
specified, the error message Gateway address not on eth0 subnet: may appear
when you try to exit Safe Mode. If this error message appears, re-run the ifconfig inet
eth0 <IP address>/<prefix length> command to set the correct prefix length.
When the prefix length is not specified, the value defaults to 32.
c. Run the following command to specify the gateway address.
ifconfig inet gateway <gateway address>
Example:
ifconfig inet gateway 198.51.100.1
d. Run the following command to specify one or more DNS servers.
net dns init <DNS server 1> <DNS server 2>
Example:
net dns init 203.50.113.55 203.50.113.90
e. Run the following command to specify the domain name.
ifconfig domainname <domain name>
Example:
ifconfig domainname corp.com
5. To prevent unauthorized access to the BMC, make sure that the BMC IP address is set to a private
non-routable IP address.
a. Run the following command to view the BMC IP address.
platform bmc show
102
0.0.0.0
Set up Storage Center Software