Table of Contents
Advertisement
Steps
1
Review the fault domains that have been created.
2
(Optional) Click Copy to clipboard to copy the fault domain information.
3
(Optional) Review the information on the Zoning, Hardware, and Cabling Diagram tabs.
NOTE:
The ports must already be zoned.
4
Click Next.
Configure iSCSI Ports
For a Storage Center with iSCSI front-end ports, enter network information for the fault domains and ports.
Prerequisite
One port from each controller within the same fault domain must be cabled.
NOTE:
If the Storage Center is not cabled correctly to create fault domains, the Cable Ports page opens and explains the issue.
Click Refresh after cabling more ports.
Steps
1
On the Set IPv4 Addresses for iSCSI Fault Domain 1 page, enter network information for the fault domain and its ports.
NOTE:
Make sure that all the IP addresses for iSCSI Fault Domain 1 are in the same subnet.
2
Click Next.
3
On the Set IPv4 Addresses for iSCSI Fault Domain 2 page, enter network information for the fault domain and its ports. Then click
Next.
NOTE:
Make sure that all the IP addresses for iSCSI Fault Domain 2 are in the same subnet.
4
Click Next.
5
Review the fault domain information.
6
(Optional) Click Copy to clipboard to copy the fault domain information.
7
(Optional) Review the information on the Hardware and Cabling Diagram tabs.
8
Click Next.
Configure SAS Ports
For a Storage Center with SAS front-end ports, the Review Fault Domains page displays information about the fault domains that were
created by the Storage Center.
Prerequisites
•
One port from each controller within the same fault domain must be cabled.
•
The ports for each fault domain must be cabled to the same server.
NOTE:
If the Storage Center is not cabled correctly to create fault domains, the Cable Ports page opens and explains the issue.
Click Refresh after cabling more ports.
Steps
1
Review the fault domains that have been created.
2
(Optional) Click Copy to clipboard to copy the fault domain information.
3
(Optional) Review the information on the Hardware and Cabling Diagram tabs.
4
Click Next.
Discover and Configure the Storage Center
63
Advertisement
Table of Contents
