Micro Control; Led Opl Control - Equipment Marketers GA025L Installation Operation & Maintenance

Operating Instructions
IMPORTANT: To stop the tumble dryer at any
time during the cycle, OPEN DOOR. To restart
the tumble dryer, CLOSE door and press
START pad.
4. When the cycle is complete, open door and remove the
laundry.
To prevent the risk of fire, remove laundry
immediately in case of power failure.

Micro Control

NC, NJ, NX and NY Control Suffixes
1. Select HIGH TEMP, MED TEMP, LOW TEMP or
DELICATES by pressing the appropriate temperature pad.
Figure 45

LED OPL Control

EO and RE Control Suffixes
1. Press the Up or Down keypad to change cycles.
To customize a cycle, refer to the Programming Manual.
2.
Press START ( ) to start selected cycle.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the START (
) pad must be pressed.
3. When the cycle is complete, open door and remove laundry.
92
Figure 44
WARNING
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
2. Insert the coin(s) in the coin slot or the card into the
opening.
3. Press START pad to start tumble dryer.
W779
IMPORTANT: To stop the tumble dryer at any
time during the cycle, OPEN DOOR. To restart the
tumble dryer, CLOSE door and press START pad.
4. When the cycle is complete, open door and remove the
laundry.
To prevent the risk of fire, remove laundry
immediately in case of power failure.
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.
After an hour the machine enters delayed tumble
and will tumble for two minutes every hour for up
to 18 hours or until the door is opened.
Figure 46
Figure 47
WARNING
Part No. 70476301ENR6
W779