Table of Contents
Advertisement
Installation
NOTE: Shaded areas indicate adjacent structure.
1
0.5 in. (13 mm) recommended between machines for removal or installation
2
Allow 2-4 in. (51-102 mm) opening at top of machine to aid in removal or installation. A removable trim piece may be used to
conceal the opening; zero clearance allowed for trim.
3
4 in. (102 mm) maximum header thickness
4
Minimum clearance permitted for remainder: 12 in. (305 mm)
5
Guard
6
Provision for make-up air
7
24 in. (610 mm) minimum, 36 in. (914 mm) recommended for maintenance purposes
8
0.25 in. (6 mm) recommended for removal or installation purposes, zero clearance allowed
Position and Level the Tumble Dryer
1.
Remove lint panel door, and unscrew the four shipping bolts
(one at each corner).
2.
Remove tumble dryer from skid.
NOTE: Do not throw bolts away – they are the
leveling legs.
3.
Remove four nuts from the literature package, and screw
one fully on to each leveling leg.
4.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
5.
Slide tumble dryer to its permanent location. Adjust
the leveling legs until the unit is level, or no more than
0.125 inch (3.18 mm) higher in the front. Refer to Figure 3
. Tumble dryer must not rock. Lock leveling legs with nuts
previously installed.
32
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
Figure 2
NOTE: The front of the tumble dryer should
be slightly higher than the rear (approximately
0.125 inch (3.18 mm)). This will prevent the
clothes, while tumbling, from wearing on the door
glass gasket.
IMPORTANT: Keep tumble dryer as close to floor
as possible. The unit must rest firmly on floor so
weight of tumble dryer is evenly distributed.
Part No. 70476301ENR6
Advertisement
Table of Contents
