Reversing Operation; Control Instructions; Dual Digital Timer Control - Equipment Marketers GA025L Installation Operation & Maintenance

b. Close panel tightly against tumble dryer frame and lock
panel securely, if applicable.
IMPORTANT: Clean lint screen and lint
compartment daily. Failure to clean the lint screen
daily will result in higher than normal temperatures
that may damage laundry.
To reduce the risk of fire and risk of lint
collecting in exhaust duct, do not operate
tumbler without lint filter in place.
2. Load Laundry
a. Open loading door and load cylinder with laundry.
Maximum drying load is:
Model
025
030
T30
(per cylinder)
035
T45
(per cylinder)
055
DO NOT OVERLOAD.
NOTE: Overloading causes slow drying and
wrinkling.
b. Close loading door. Tumble dryer will not operate with
the door open.
3. Determine Control Type and Temperature Setting
a. Refer to the various controls and follow the instructions
for the appropriate control type.
b. The type of fabric being dried will determine the
temperature setting. Consult the fabric care label or
fabric manufacturer to determine proper temperature
setting.
Part No. 70476301ENR6
WARNING
W772
Pound (Kg)
25 (11.3)
30 (13.6)
30 (13.6)
35 (15.9)
45 (20.5)
55 (24.9)
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
IMPORTANT: Always follow the fabric
care instructions supplied by the garment
manufacturer.
4. Remove Laundry
a. When the cycle is complete, open door and remove the
laundry.

Reversing Operation

Tumble dryers with the reversing option prevent the tangling of
large pieces of laundry and minimize wrinkling. These tumble
dryers are equipped with a second motor and additional controls
which reverse the rotation direction of the cylinder.
Some models may have a switch or touchpad in the control panel
area so the operator can select the reversing or nonreversing
operation. In nonreversing mode, the cylinder will always turn
clockwise (as viewed from the front of the tumble dryer). If
the cylinder is turning counterclockwise when switched to
nonreversing, it will continue for a few seconds and then start up
in the proper direction. Refer to Programming Manual for more
information on reversing.
IMPORTANT: Then set the reverse control switch
to "nonreversing" and note that the cylinder turns
constantly clockwise as viewed from the front of the
tumble dryer. If not, interchange L1 and L2 service
leads to the reverse drive motor.

Control Instructions

Dual Digital Timer Control

QT and RQ Control Suffixes
1. Select HIGH, MED, LOW or NO HEAT by turning the
temperature knob.
HIGH
MED
LOW
Figure 29
Operating Instructions
Temperature 190°F
(88°C)
Temperature 170°F
( 77°C)
Temperature 120°F
(49°C)
87