Installing Ce Gas Drying Tumble Dryer; General Information; Ce Orifices - Equipment Marketers GA025L Installation Operation & Maintenance

Installation
• Apply warning sticker on front panel of machine, in language
appropriate to country of sale (included in literature packet).

Installing CE Gas Drying Tumble Dryer

General Information

This information is to be used when installing gas tumble dryers
in countries and/or on gases different than the machine's factory
configuration. Tumble Dryers are supplied from the factory for
operation on Natural Gas 1000 Btu/cu. ft. (8914 kcal/m
L.P. Gas 2500 Btu/cu. ft. (22,250 kcal/m
group H/E, designation G20 and L.P. gas group B/P, designation
G30. To install machines in any other country, or on any other
gas, requires some level of modification.
Machines are built in two different configurations:
• Natural Gas – regulated/governor
• Liquefied Petroleum (L.P.) Gas – not regulated/no governor
For converting models from Natural Gas to L.P. Gas:
025 series
030 series
035 series

CE Orifices

Gas Gas Gas
Type Family Group
Natural Second I
2H(E)
Gas
40
3
), or
3
), with natural gas
M4699P3
M4703P3
M4711P3
Supply
Pressure
Gas in. wc
Designation (mbar, kPa)
G20 8/10
(20/25, 2.0/2.5)
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
055 series
T30/T45 series
Serial plates supplied from the factory are configured for GB/
IE/PT/ES/IT/GR/LU/CH/BE. These instructions pertain to the
situations when the country of use or gas supply is different than
that on the serial plate. If applicable, peel off the appropriate
country sticker (included with machine) and apply it to the serial
plate over the existing country information.
These instructions are only valid if the following country code
is on the appliance: GB/IE/PT/ES/IT/GR/LU/CH/BE. If this
code is not present on the appliance, it is necessary to refer
to the technical instructions which will provide the necessary
information concerning the modification of the appliance to the
condition of use for the country.
Before installation, check that the local distribution conditions,
nature of gas and pressure, and the adjustment of the appliance
are compatible.
Table 1 describes the different gases that are available in
different CE countries, and how the machines need to be
configured to operate with those gases. In the CE, there are
Natural Gas configurations that do not allow for machine
regulation and L.P. Gas configurations that must be regulated.
For L.P. Gas, third family B/P at 50 mbar (5 kPa), order
Regulated Natural Gas machines and convert according to Table
1.
Manifold
Pressure
in. wc Capacity
(mbar, kPa) Model
3.25 25
(8, 0.8)
30
T30
35
M4924P3
M4734P3
Orifice
Diameter Orifice
in. (mm) Part No. Quantity
0.1540 M401020 1
(3.9)
0.1570 M402996 1
(4.0)
0.1570 M402996 2
(4.0)
0.1820 M411371 1
(4.6)
Part No. 70476301ENR6