Electrical Requirements; Auxiliary Alarm; To Reverse The Loading Door (025, 030, 035 And 055 Series) - Equipment Marketers GA025L Installation Operation & Maintenance

Electrical Requirements

WARNING
Electrical power must be provided to tumbler at
all times. The fire suppression system will be
inoperative if the main electrical power supply is
disconnected.
No independent external power source or supply connection is
necessary. Power to operate the 24 Volt fire suppression system
is from the rear junction/contactor box.

Auxiliary Alarm

The fire suppression system provides an auxiliary output signal
when the system is activated. During tumble dryer installation,
you have the option to connect a separate alarm system to this
auxiliary output. Potential uses of the auxiliary output include,
but are not limited to: (1) sounds an alarm, (2) activates a
building sprinkler system, (3) notifies a fire department, etc. Use
of the auxiliary output is not required for the fire suppression
system to operate, but may be used for additional protection.
The connection to the auxiliary output is made through the FS-1
and FS-2 fast-on connections inside the fire suppression control
box. Refer to Figure 7 . The relay is rated for 24 VAC, 5.2 Amp,
sealed current.
NOTE: The auxiliary output is activated during fire
suppression system maintenance test sequence.
Consider this fact prior to your system test every three
months. (Example: If the external system uses the
auxiliary output to call the fire department, inform the
fire department before and after the fire suppression
system maintenance test.)
Part No. 70476301ENR6
W690
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
1 Opening for Auxiliary Alarm Cable
2 Fuse
3 Auxiliary Alarm Fast-On Connection
4 Test Button
5 Light
Reset Button
6
7 Auxiliary Alarm Fast-On Connection
Figure 7
To Reverse the Loading Door (025, 030,
035 and 055 Series)
The tumble dryer is delivered with a right hinged door, but
the door can be changed to a left hinged position.
1. Disconnect power supply to tumble dryer.
2. Unlock and remove control panel. Remove two control
assembly mounting screws from right side. Swing open
control to access upper flange right guide lug assembly.
Refer to Figure 8 .
3. Remove lint panel.
IMPORTANT: Support door and hinge assembly
securely to prevent it from dropping once side
screws are removed from door hinge lug.
Installation
35