Mdc Coin And Card Control - Equipment Marketers GA025L Installation Operation & Maintenance

Figure 39
2. To use a Time Dry or Custom Cycle, refer to the
Programming Manual.
3. Press START pad to start tumble dryer.
Figure 40
NOTE: All pads can be pressed in any sequence
without damaging control or tumble dryer. To stop
the tumble dryer at any time, open the door or
press STOP.
Figure 41
NOTE: The window display will flash. Press STOP
twice (within three seconds) to end the cycle
and reset the control to idle status. To restart the
tumble dryer, CLOSE door and press START pad.
IMPORTANT: If the loading door or lint panel door
is opened during the cycle, the heating system
will shut off and the motor will stop. To restart the
cycle, both doors must be closed and the PUSH
TO START button must be pressed in.
4. When the cycle is complete, open door and remove the
laundry.
Part No. 70476301ENR6
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
To prevent the risk of fire, remove laundry
immediately in case of power failure.
NOTE: This machine includes an anti-wrinkle/
extended tumble feature. After the drying cycle
is complete, the cylinder will tumble without heat
every few minutes. The intermittent tumbling will
continue for one hour or until the door is opened.

MDC Coin and Card Control

BB, BC, BG, BK, BL, BW, BX, BY and BZ Control
Suffixes
1. Select temperature by pressing the appropriate temperature
pad.
HIGH
MED
LOW
DELICATES
Figure 42
2. Insert the coin(s) in the coin slot, or the card into the
opening.
3. Press START pad to start tumble dryer.
Operating Instructions
WARNING
Temperature 190°F
(88°C)
Temperature 180°F
(82°C)
Temperature 160°F
(72°C)
Temperature 130°F
(54°C)
Figure 43
W779
91