Before Placing Tumble Dryer Into Service - Equipment Marketers GA025L Installation Operation & Maintenance

1 Beginning Location of Door Switch
Wire Ties
2
3 Original Switch Location
4 Original Plug Location
5 Top Panel
6 Panel Cutout
9. Place front panel on machine, loosely attach four bottom
screws. Connect door switch harness to switch in new
location. Install door assembly and four front panel side
screws loosely. Refer to Figure 11 .
10. Check lint panel fit, adjusting front panel up or down as
required. Tighten four front panel side screws to maintain
position of front panel for proper lint panel clearance.
11. Remove lint panel. Fully tighten bottom screws on front
panel.
12. Reinstall top screws and guide lugs.
13. Adjust door catch if necessary to allow 7 – 15 pounds
(0.48 – 1.03 bar) pull at center of handle.
14. Reinstall control assembly using mounting screws.
15. Reinstall control panel and lint panel.
Part No. 70476301ENR6
Figure 10
©
Published by permission of the copyright owner - DO NOT COPY or TRANSMIT
IMPORTANT: Restore power to tumble dryer and
test for proper operation of loading door switch.
Tumble dryer should not start with door open; an
operating tumble dryer should stop when door is
opened.
1 Switch (New location)
2 Plug (New location)
3 Door Assembly
4 Side Screw
NOTE: If machine is converted back to right hand
hinge operation, the door switch harness must be
rerouted. Harness must be rebundled with the lint
panel switch harness. Wire ties must be used to
secure harnesses. Wire ties (Part No. 55881) can be
ordered from Genuine Parts.
Before Placing Tumble Dryer into
Service
1. Remove or open all panels and check accessible bolts, nuts,
screws, terminals and fittings for tightness.
2. Replace all panels and guards.
3. Remove and discard wire tie from the airflow switch so it
can swing freely. Refer to Figure 12 .
Installation
Figure 11
37