Bosch D9068 Operation And Installation Manual page 73

D9068 | Operation and Installation Guide | Appendix F: D8024/D10024/D10024A Analog
.
Table 23: Analog Reports and Causes (Continued)
Analog FACP Comments
Event
Network Failure Control panel
generated.
Remote Future
Programming
Failed*
Remote Future
Programming
Successful*
Control Panel Dialer generated.
Communication
Failure
Control Panel Dialer generated.
Communication
Restore
System Trouble - Dialer generated.
Keypad Installed
System Trouble - Dialer generated.
Restoral Keypad
Installed
System Trouble – Dialer generated.
Communications
Fault
System Trouble Dialer generated.
Restoral -
Communications
Fault
System Trouble - Dialer generated.
Programming
Error
System Trouble Dialer generated.
Restoral -
Programming
Invalid Events 32 to 39, 94 to
255
* Event is not supported at this time.
Bosch Security Systems, Inc. | 3/13 | F01U071094-07
Cause
A network failure is detected.
There is a problem with programming.
The remote programming is successful.
The control panel lost communication.
This message is sent if control panel
communications are restored. If the were any off-
normal control panel conditions prior to losing
communications, and the control panel is normal, a
System Reboot Reset is also sent when
communications are restored.
No keypad activity for 3 minutes.
The keypad trouble is restored.
There is a communication error.
The communication is restored.
There is a programming error.
The programming error is restored.
Not valid.
FACP Operation
73