Using The Keypad; Figure 25: Programming Key Sequence For System Date - Bosch D9068 Operation And Installation Manual

D9068 | Operation and Installation Guide | 5.0 Programming
4.5 Reset
Reset the D9068 in one of four ways:
1. At the LCD remote keypad, press [4] to
select Reset from the Main Menu or
press [Reset]. Pressing either key
resets the D9068 only when
off-normal conditions are present. The
system sends an Open Reset Report with
the user ID parameter of 99.
2. Exit from the Test Mode. The system
sends an Open Reset Report with the
user ID parameter of 99.
3. Exit from the Programming Mode. The
system sends an Open Reset Report with
a user ID parameter of 01.
4. Power up the D9068. No Open Reset
Report is sent.
32
5.0 Programming
5.1

Using the Keypad

Use the D7033/FMR-DACT-KEYPAD Keypad
Programmer to do all programming for the
D9068. To properly program the D9068, you
must always press the [# Command] and
[* Clear] keys in addition to the key(s)
necessary to make specific programming
entries.

Press [# Command] to accept an entry
into the D9068.

Press [* Clear] after pressing
[# Command] to return to the submenu
or menu selections.
Refer to Figure 25 for the complete
programming key sequence for setting the
D9068 operational date.
Figure 25: Programming Key Sequence for
1
0
Program
1 - Press [0 Program] to enter the
Programming Mode Menu.
2 - Press [1] to enter the Prog Time
submenu.
3 - Press [1] again to select SYSTEM for
the system
date and time.
4 - Enter the current date using the
keypad keys [0] to [9].
5 - Press [# Command] to enter the date
into the system.
6 - Press [* Clear] to move to the next
menu item, or to return to previous
menus.
Bosch Security Systems, Inc. | 3/13 | F01U071094-07
System Date
4
3
2
ENTER DATE
1 1
MMDDYY: 010100
When you enter the Programming
Menu (Level 2), you no longer
need to press [0] to re-enter
the Programming Menu. If you
press [0] while in the
Programming Menu, the keypad
emits a three-beep error tone.
5 6
# *
Command Clear