Q U I C K S T A R T G U I D E
KEPCO
This guide gives a brief introduction to the BOP 1KW-MG/ME Power supply, shows simple load connections, and allows you to
verify the power supply is working. The guide also shows you how to use the front panel controls to perform the most commonly
used functions.
BOP 1KW models with MG and ME suffixes are identical except that the MG units have a factory-installed GPIB interface
and in the ME units the GPIB interface is replaced with a LAN interface. Unless otherwise noted this guide applies to both
models.
ACCESSING MANUALS.
applicable Operator's Manual from
www.kepcopower.com/support/opmanls.htm#bop-1k
Refer to the BOP 1KW-MG/ME Operator's Manual for full specifications, installation considerations and operating instruc-
tions, including an Installation/Operation Summary which includes hyperlinked references to detailed procedures, but
which can be printed as a handy reference. The BOP 1KW-MG/ME Operator's Manual also includes a full description of
the digital interfaces and the SCPI command language.
FIRMWARE VERSION. Refer to
sion is installed.
ACCESSING DRIVERS. Drivers are accessed from www.kepcopower.com/drivers/drivers-dl3.htm.
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
©2018, KEPCO, INC
Data subject to change without notice
An ISO 9001 Company.
BOP 1KW-MG/ME POWER SUPPLY
First determine your Firmware Version (see below), then download the BOP 1KW-MG, ME
www.kepcopower.com/support/bophifirm.htm
http://www.kepcopower.com email: hq@kepcopower.com
228-1692 REV 8
BOP
1KW
-MG/ME
to determine which firmware ver-
1