Inspecting And Unpacking The Battery Cabinet - Eaton Power Xpert 9395 Installation Manual

INSTALLATION PLAN AND UNPACKING
3.3

Inspecting and Unpacking the Battery Cabinet

3-10
Power Xpert 9395 Integrated Battery Cabinet (Model 1085 and 1085HR) Installation Manual
The battery cabinet is palleted separately for shipping. The cabinet is shipped bolted
to a pallet consisting of four angle metal supports secured to two four-inch by six-inch
wood supports, as shown in Figure 3‐5, and protected with outer protective
packaging material.
The battery cabinet is extremely heavy (see Table 3‐1 on page 3-2). If unpacking instructions are not closely
followed, the cabinet may tip and cause serious injury.
1. Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact your service representative
immediately.
NOTE For the following step, verify that the forklift or pallet jack is rated to handle the weight of the
cabinet (see Table 3‐1 for cabinet weight).
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site,
or as close as possible, before unpacking. Insert the forklift or pallet jack's forks
between the pallet supports on the bottom of the unit.
Do not tilt the UPS cabinet more than 10° from vertical or the cabinet may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft)
on each side for removing the cabinet from the pallet.
NOTE The battery cabinet is shipped with a debris shield covering the ventilation grill on top of the unit.
Do not remove the debris shield until installation is complete.
4. Remove the protective covering from the cabinet.
5. Remove the packing material, and discard or recycle in a responsible manner.
6. Inspect the contents for any evidence of physical damage, and compare each
item with the Bill of Lading. If damage has occurred or shortages are evident,
contact your service representative immediately to determine the extent of the
damage and its impact upon further installation.
NOTE While waiting for installation, protect the unpacked cabinet from moisture, dust, and other harmful
contaminants. Failure to store and protect the UPS properly may void your warranty.
C A U T I O N
C A U T I O N
C A U T I O N
S
www.eaton.com/powerquality
164201687 Rev 4