Steering Select Switch; Outrigger Control - Xtreme xr1255 Operation And Safety Manual

Operator Cab
Fig 38. Regeneration Menu
FAULT CONDITION POP-UPS
A fault condition may trigger a pop-up dialog box describing
the nature of the fault. A soft button may need to be pressed
to acknowledge the fault.
BACKUP CAMERA (OPTIONAL)
The display automatically changes to backup camera when
the transmission is in REVERSE. When the transmission is in
NEUTRAL or FORWARD, the display can be switched from the
GAUGE DISPLAY to the BACKUP CAMERA by using the select
button. Press it again to return to the GAUGE DISPLAY.

Steering Select Switch

DO NOT change steering modes until the forklift slows
or comes to a complete stop. Align all four (4) wheels
perpendicular to the axle, before changing steering mode.
Changing steering modes at higher travel speeds can make
the forklift unstable, and cause a loss of control, which
could result in death, serious injury, or property damage.
The Steering Select switch has three (3) steering positions:
Crab, Two Wheel Steering (2W), and Four Wheel Steering (4W).
Figure 39. Steering Select and 2-Wheel Rear Switches
Warning

Outrigger Control

The outrigger toggle switches are used to lower and raise the
outriggers. The outrigger indicators illuminate when the out-
riggers are fully extended and on the ground (Figure 29).
Figure 40. Outrigger Toggle Switches
Figure 41. Outriggers Down
Once outriggers are fully extended, the transmission is disen-
gaged, and the frame sway is locked. Frame sway lock can be
overridden with the frame sway override switch.
Figure 42. Outriggers Up
41 Operation Manual