Operation; Pre-Operation Inspection - Xtreme xr1255 Operation And Safety Manual

Operation

Pre-Operation Inspection

To perform the pre-operation inspection make sure the
forklift is NOT running, the engine is cool, the forklift is parked
on level ground, the boom is completely retracted, and the
frame is level.
NOTE: Copy and use the Pre-Operation Inspection Checklist
in this section.
Wear appropriate protective clothing. Personal protective
equipment can include, but is not limited to hardhat,
gloves, footwear, safety glasses or goggles, and hearing
protection. Make sure clothing is snug and properly belted.
DO NOT wear loose clothing, jewelry, watches, or anything
that can catch on forklift controls, moving parts, etc. Failure
to wear the proper protective clothing could result in death
or serious injury.
Perform a pre-operation inspection and
functional tests at the beginning of each work
shift. Perform the pre-operation inspection
first. DO NOT perform the pre-operation
inspection with the engine running or hot.
Contact with moving or heated parts could cause death or
serious injury.
Perform a pre-operation inspection and func-
tional tests in an open area.
Become familiar with all safety and hazard la-
bels, regulations, and procedures. Make sure
all proper labels are attached to the forklift
and remain legible.
Remove forklift from service and place "Do
Not Operate" tags on the Starter switch and
steering wheel if anything is found to be in
need of repair or maintenance, defective, or
unsafe in any way.
Operation Manual
Warning
Contact with hot surfaces and the exhaust
pipe after the forklift has been operated
could result in serious personal injury.
Always check the condition of the seat belt
and mounting hardware before operating the
forklift. If the seat belt or mounting hardware
is defective, it may not properly restrain the
operator, resulting in death or serious injury.
• DO NOT operate the forklift until the seat belt or mount-
ing hardware is replaced, if worn or damaged.
• The seat belt MUST be worn while operating the fork-
lift. Failure to wear the seat belt could result in death or
serious injury.
a hydraulic leak. Escaping hydraulic fluid under pressure,
even a pinhole size leak, can penetrate body tissue, which
could cause death or serious injury. If hydraulic oil is inject-
ed into your skin, a doctor familiar with this type of injury
must treat it immediately.
hands. Remove the hydraulic tank filler cap slowly to relieve
pressure. Relieve all pressure in a hydraulic system before
any caps, lines, fittings, or related items are disconnected
or removed.
Never remove the radiator cap while the
engine is hot. The cooling system is under
pressure. Hot coolant could cause severe
burns or eye injury. Wear protective clothing
and safety glasses.
46
Operation
Caution
Warning
Check hydraulic oil lines, tubes,
and hoses carefully. DO NOT
use your bare hand to check for
leaks. Always use a board or
cardboard when checking for
Serious injury could result from
hydraulic oil pressure or hot
oil. DO NOT remove a hydrau-
lic tank filler cap unless it is
cool enough to touch with bare