Table of Contents
Advertisement
Manual Regeneration
DO NOT leave forklift unattended during manual
regeneration.
The manual regeneration should be performed by qualified
personnel.
This procedure requires the engine to run
continuously for 15 to 30 minutes. The forklift cannot be
operated during this procedure.
1.
Stop the forklift and set the parking brake (Do not release
the parking brake until the regeneration is complete).
2.
Verify the engine is at low idle.
3.
Verify the fuel level is sufficient for 30 minutes of operation.
4.
Verify the accelerator pedal is not depressed.
5.
Press the Manual Regeneration Button.
6.
The engine speed will increase to 1000 RPM and the High
Exhaust System Temperature (HEST) indicator will be
displayed.
7.
Do not press the accelerator pedal.
8.
Allow the manual regeneration to complete without
interruption.
9.
The engine speed will decrease to low idle and the High
Exhaust System Temperature (HEST) indicator will turn
off.
10. The manual regeneration is complete.
11. Turn the engine off and re-start to reset the Exhaust
Aftertreatment System.
Stopping Travel
1.
Stop the forklift by applying the service brake pedal.
2.
Slow the forklift until it comes to a complete stop.
3.
Move the travel select lever to NEUTRAL (N).
4.
Set the parking brake to ON (engaged).
To prevent death, serious injury, or property
damage, apply service brakes until the forklift
comes to a complete stop, move travel select
lever to NEUTRAL (N), set the Parking Brake
switch to ON (engaged), lower and retract the
boom, and shut off the engine before exiting the forklift.
Operation Manual
Caution
Warning
Changing Travel Direction
1.
Stop the forklift by applying the service brake pedal.
2.
Move the travel select lever to FORWARD or REVERSE.
Make sure the forklift comes to a complete
stop before moving the travel select lever. A
sudden change in direction of travel, while
carrying a load, can reduce stability and/
or cause the load to shift or fall, which could
result in death, serious injury, or property damage.
3.
Release the service brake pedal.
4.
Slowly press the accelerator pedal to start travel.
Shut Down Procedure
1.
Park forklift on level ground, if possible.
2.
Stop the forklift by applying the service brake pedal.
3.
Place the travel select lever in NEUTRAL (N) and set the
parking brake to ON (engaged).
4.
Lower the boom and rest carriage on ground.
5.
Turn the ignition key to OFF and remove the key.
6.
If the forklift is parked on an incline, block the wheels.
Refueling
open flames away from the forklift.
NOTE: The fuel tank capacity is 48 gallons.
•
Make sure the forklift is level to obtain an accurate fuel
level reading.
•
Shut off the engine.
•
Ground the fuel nozzle against the filler neck to avoid
sparks.
58
Operation
Warning
Warning
Engine fuel is flammable and
can cause a fire or explosion
resulting in death or serious
injury. DO NOT smoke while
refueling and keep sparks and
Hide quick links:
Advertisement
Table of Contents
