Table of Contents
Advertisement
3.7 Adjusting the TeamPad 7500 Setup Settings
3.7.1 Changing the setup settings
The following describes the operation to change the setup settings.
(1) Press the [PWR] key while holding down the [FUNC] key, [SYS] key, and an optional location
on the touch panel when the power supply of the unit is being turned off.
Ø This unit is started, and the [Change setting] window for network settings is displayed.
(2) Change the setup settings according to your needs.
>>Reference>> From the operation (2) in "2.1 Setting the Network" to "2.3 Enter the
3.7.2 Initializing the setup settings
The following describes the operation to initialize the setup settings to the mode when this unit is
purchased.
& Advice &
•
The [Change setting] window for network settings is displayed by turning on this unit
after initializing the setup settings. Set the network.
•
The touch panel calibration mode is not initialized even if the setup settings are
initialized.
(1) Press the [PWR] key while holding on the [FUNC] key, [SYS] key, and an optional location on
the touch panel when the power supply of this unit is being turned off.
Ø This unit is started, and the [Change setting] window for network settings is displayed.
(2) Tap on the [No] button on the [Change setting] window for network settings.
Ø The screen keyboard and [Power savings and connecting to Terminal Server] window is
displayed.
(3) Click on the [Initialize] tab on the [Power savings and connecting to Terminal Server] window.
(4) Click off the [Initialize] check box in the [Initialize] tab.
Settings for the Terminal Server/Power Saving" about the setup settings.
35
Advertisement
Table of Contents
