Fujitsu TeamPad PBT7500-16 Operation Manual page 25

NOTE
•
This unit must not be subjected to shock when setting this unit upright in the charging
stand. Problems may occur with the unit or to the charging stand if the unit is
subjected to shock.
•
When the LED flashes green at an interval of approximately 0.5 seconds, it indicates
that charging is not happening correctly. In this case, the battery voltage may be below
the specified voltage, or even the charged voltage may not reach the specified value,
or the battery may simply be damaged.
The battery should be replaced with a new one. The LED turns off when the plug of
the AC adapter is pulled out of AC inlet.
•
Charging cannot be performed when the LED flashes red, because the AC adapter
voltage is below the specified voltage
The AC adapter may have a problem, therefore contact a field support service
representative. The LED turns off when the plug of the AC adapter is pulled out of
the AC inlet.
Charge with the AC adapter
The method described below is to connect the AC adapter to the 7500 and charge the unit, while
the battery remains in the unit. The AC adapter is required for using this method. The picture below
illustrates this.
(1) Turn the handheld off.
(2) Connect the AC adapter to the 7500 using the ac adapter port.
(3) Verify the voltage levels of the AC adapter match the AC outlet. Insert the plug of the AC
adapter into the AC outlet.
Ø Charging will automatically begin.
AC Adapter PBT7631-11
12