Table of Contents
Advertisement
about 0.5 seconds. Replace with a new battery.
There might be a hardware fault if the LED flashes red for 5 seconds at an interval of
about 0.5 seconds. Contact a field support service representative.
(2) Tap on the [Yes] button on the [Change Settings] window for network settings.
Ø The screen keyboard and control panel are displayed.
>>Reference>> "3.8 Using the Screen Keyboard" for more information on the screen
keyboard.
& Advice &
Tap on the [No] button to set the terminal server/power saving without changing the
network settings when this unit is set up again. By tapping on the [No] button, the screen
keyboard and the [Power savings and connecting to Terminal Server] window is
displayed.
>>Reference>> "2.2 Setting to connect the Server" about the [Change setting] window
for network settings.
(3) Double-tap on the [Network] icon on the control panel.
Ø The [Network] window is displayed.
(4) Set the items on the [Network] window according to the explanation displayed on the
[Network] window.
Tap on the [OK] button after the setting has been terminated.
Ø The [Network] window is closed.
NOTE
Ignore the following message displayed, and tap on the [OK] button:
"The new setting becomes valid when the adapter is used the next time. The new setting
becomes valid by reinserting the adapter into the device after taking it out of the device if
the adapter has been Inserted into the device."
NOTE
If using a Symbol Spectrum24 card, refer the following action.
If using another vender's RF card, please refer to that specific setup instruction for
that vender's RF card.
(5) Double-tap on the [Spectrum24 Settings] icon on the control panel to change the SS radio
setting.
Ø The [Spectrum24 Settings] window is displayed.
(6) Set the items on the [Spectrum24 Settings] window.
Tap on the [OK] button after the setting has been terminated.
17
Advertisement
Table of Contents
