Table of Contents
Advertisement
center of [+]. In this case, tap on the [+] mark again.
& Advice &
The touch panel calibration can be stopped by pressing the [ENT] key if the [Cancel]
button is not valid.
Ø The tapped [+] disappears, and another [+] is displayed at a different position.
However, the touch panel calibration will stop, and the unit will restart if the [Cancel]
button is tapped.
(3) Tap on [+] with a pen. Five [+] symbols are sequentially displayed. Tap on these five symbols
with a pen in the order indicated on the display.
Ø The touch panel calibration completion window is displayed by tapping on the fifth [+]
symbol.
(4) Tap on the [OK] button on the message window.
& Advice &
The touch panel calibration can be terminated by pressing the [ENT] key if the [OK]
button is invalid.
Ø
This unit is restarted.
% Request %
•
The setup settings are initialized if the battery becomes insufficient from when the
[OK] button is tapped until this unit is restarted. Perform the setup functions again.
33
Advertisement
Table of Contents
