Table of Contents
Advertisement
2 TeamPad 7500 Series Setup
Correct setup of the TeamPad 7500 series device consists of the following tasks:
Network Settings
Change network settings and Spread Spectrum radio settings.
Server Settings
Set connect entry to server.
Terminal Server/Power Saving Settings
Set power saving and auto-connect to server settings.
NOTE
Before setup can begin, please charge the battery and insert it into the handheld. For more
information, please refer to:
1.3 Battery Usage
>>Reference>> "3.7 Adjusting the TeamPad 7500 Setup Settings" when it is set up again.
2.1 Setting the Network
(1) Turn this unit on by pressing the PWR key until LED flashes bright green (about 1 second).
Ø This unit will boot up, and the [Change Settings] window for network settings will be
displayed.
NOTE
This battery might be damaged if the LED flashes green for 5 seconds at an interval of
16
Advertisement
Table of Contents
