Filter2; Filters - Access Virus Rack XL User Manual

68
CHAPTER 7
The Parameters
í
FILTER 2
KEY FOLLOW
same as FILTER 1
MODE
same as FILTER 1
ENV POLARITY
Switches back and forth between positive
(POS) and negative (NEG) ENV AMOUNTs for
Filter-2 (see appropriate section).
01111111111111111112

1 FILTER2

EnvPolarity Pos≤
61111111111111111154
CUTOFF LINK
Switches the knob and the parameter CUTOFF
2 (see appropriate section) back and forth be-
tween two operating modes:
- ON In this mode, CUTOFF 2 operates rela-
tively to the CUTOFF knob value rather than
absolutely (OFFSET): The cutoff frequency of
the second filter is - like the first filter - deter-
mined by the CUTOFF value. However you
can dial in an offset (relative ascending or de-
scending deviation) of the frequency via the
CUTOFF 2 knob. At the center position (12
o'clock) of CUTOFF 2, the frequencies of the
two filters are identical.
- OFF Now,the CUTOFF and CUTOFF 2 knobs
are no longer linked and CUTOFF 2 operates
absolutely in a control range of 0 to 127. In
this case the CUTOFF and CUTOFF 2 knobs
are two independent control features that de-
termine the respective cutoff frequencies for
Filter-1 and 2. CUTOFF LINK pertains exclu-
sively to the CUTOFF 2 knob and the corre-
sponding parameter. CUTOFF 2 has no
influence on the other parameters of the sec-
ond filter.
01111111111111111112
1 FILTER2
CutoffLink
61111111111111111154
í

FILTERS

BALANCE
Has different functions depending on the FIL-
TER ROUTING setting (see appropriate section
as well): In the parallel FILTER ROUTING oper-
ating modes PAR 4 and SPLIT, it controls the
balance of volume levels between the two filters
- or in actuality SATURATION and Filter-2.
Technically, in the serial FILTER ROUTING oper-
ating modes SER 4 and SER 6, the left half and
the right half of the control range address differ-
ent parameters: When the knob is set to the far
left position, you will hear Filter-1/Saturation ex-
clusively, whereas Filter-2 is blended into the
mix as you rotate the knob towards the center
position. When the knob is set to the far right
position, you will hear Filter-2 exclusively,
On≤