Access Virus Rack XL User Manual page 116

116
CHAPTER 8
The Multi Mode Parameters
CHAN VOLUME INIT
This parameter relates to the Channel Volume
Controller (#7). ChanVolInit lets you determine a
preset level that is activated when you switch to
this MULTI. This is an option that works well for
live applications, for example to set volume lev-
els that will later be changed via an expression
pedal. When ChanVolInit is disabled (set to
OFF), the initial Channel Volume value is re-
tained when you switch to this MULTI. This ini-
tial value may have been determined by the
expression pedal or by the most recently active
MULTI patch.
í
Note: The Channel Volume Controller never
changes when you switch from one SINGLE to
another. It always retains the most recently set
value.
01111111111111111112
1 B36 101BASS RP
PartDetune
61111111111111111154
CHAN VOL RX
ENABLE Switches a given PART's MIDI receive
mode for MIDI Controller #7 (volume) on (Ena)
and off (Dis).
01111111111111111112
1 B36 101BASS RP
MidiVolume
61111111111111111154
PRIORITY
This parameter lets you control how the Vi-
rus"steals notes when its polyphonic perform-
ance is maxed out. In the first position, "LOW",
the voices of all PARTs have the same priority
when one voice is switched off to accommo-
date a new voice. When you set the Priority of a
PART to "High", the Virus will not "steal" any
notes from the voices of this PART. Use this pa-
rameter sparingly. In other words, if you set all
Parts to High, you're defeating the purpose of
this parameter. In this case, it wouldn't have any
effect since the priority of all voices is the same.
01111111111111111112
61111111111111111154
KEYRANGE
In MULTI mode, you can limit the note range of
individual PARTs. Use the LowKey and HighKey
parameters to define the upper and lower limits
of the note range to which the PART will re-
spond. This lets you assign the sounds of sev-
+10≤
eral PARTs that are addressed by the same
MIDI channel to different keyboard zones to
create what are called split sounds.
If, however, you adjust the two parameters so
that the value of LowKey lies above that of
HighKey, the note range between these two
high and low limits is disabled and the PART will
respond only to notes the lie above and below
this zone.
í
The two parameters may be entered in the
Dis≤
usual way via the VALUE buttons and the VAL-
UE knobs as well as directly via keyboard. For
the latter option, press the VALUE buttons si-
multaneously and then press the desired key on
the keyboard.
1 B36 101BASS RP
ChanVolInit Off≤