Configuring Ipodwdm - Cisco 6000 Series Configuration Manual

Configuring Dense Wavelength Division Multiplexing Controllers
Command or Action
Example:
RP/0/RP0/CPU0:router(config-dwdm)# commit
Step 9 admin-state in-service
Example:
RP/0/RP0/CPU0:router(config-dwdm)# admin-state
in-service
Step 10 show controllers dwdm interface-path-id g709
Example:
RP/0/RP0/CPU0:router# show controller dwdm 0/1/0/0
optics
What to Do Next
All interface configuration tasks for the Gigabit Ethernet interfaces still must be performed in interface
configuration mode. Refer to the corresponding modules in this book for more information.

Configuring IPoDWDM

This section provides the following configuration procedures:
Configuring the Optical Layer DWDM Ports
Use the following procedure to configure the Optical Layer DWDM ports.
SUMMARY STEPS
1. configure
2. controller dwdm interface-path-id
3. network port id id-number
4. network connection id id-number
5. Do one of the following:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
• end
•
• commit
Purpose
• Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
• Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Places the DWDM port in In Service (IS) state, to support
all normal operation.
Displays the G.709 Optical Transport Network (OTN)
protocol alarms and counters for Bit Errors, along with the
FEC statistics and threshold-based alerts.
What to Do Next
135