Cisco 6000 Series Configuration Manual page 65

Configuring Ethernet OAM
Command or Action
Step 17 require-remote mode {active|passive}
Example:
RP/0/RP0/CPU0:router(config-eoam)# require-remote
mode active
Step 18 require-remote link-monitoring
Example:
RP/0/RP0/CPU0:router(config-eoam)# require-remote
link-monitoring
Step 19 require-remote mib-retrieval
Example:
RP/0/RP0/CPU0:router(config-eoam)# require-remote
mib-retrieval
Step 20 action capabilities-conflict {disable | efd |
error-disable-interface}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
capabilities-conflict efd
Step 21 action critical-event {disable | error-disable-interface}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
critical-event error-disable-interface
Step 22 action discovery-timeout {disable | efd |
error-disable-interface}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
discovery-timeout efd
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
Configuring an Ethernet OAM Profile
Purpose
Requires that active mode or passive mode is configured
on the remote end before the OAM session becomes active.
Requires that link-monitoring is configured on the remote
end before the OAM session becomes active.
Requires that MIB-retrieval is configured on the remote
end before the OAM session becomes active.
Specifies the action that is taken on an interface when a
capabilities-conflict event occurs. The default action is to
create a syslog entry.
Note • If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Specifies the action that is taken on an interface when a
critical-event notification is received from the remote
Ethernet OAM peer. The default action is to create a syslog
entry.
• If you change the default, the log keyword
Note
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
Specifies the action that is taken on an interface when a
connection timeout occurs. The default action is to create
a syslog entry.
Note • If you change the default, the log keyword
option is available in Interface Ethernet
OAM configuration mode to override the
profile setting and log the event for the
interface when it occurs.
53