Verifying The Ethernet Oam Configuration - Cisco 6000 Series Configuration Manual

Verifying the Ethernet OAM Configuration

Command or Action
Step 5
commit
Example:
RP/0//CPU0:router(config-if)# commit
Step 6 end
Example:
RP/0//CPU0:router(config-if)# end
Verifying the Ethernet OAM Configuration
Use the show ethernet oam configuration command to display the values for the Ethernet OAM configuration
for a particular interface, or for all interfaces. The following example shows the default values for Ethernet
OAM settings:
RP/0/RP0/CPU0:router# show ethernet oam configuration
Thu Aug
GigabitEthernet0/4/0/0:
Hello interval:
Link monitoring enabled:
Remote loopback enabled:
Mib retrieval enabled:
Uni-directional link-fault detection enabled:
Configured mode:
Connection timeout:
Symbol period window:
Symbol period low threshold:
Symbol period high threshold:
Frame window:
Frame low threshold:
Frame high threshold:
Frame period window:
Frame period low threshold:
Frame period high threshold:
Frame seconds window:
Frame seconds low threshold:
Frame seconds high threshold:
High threshold action:
Link fault action:
Dying gasp action:
Critical event action:
Discovery timeout action:
Capabilities conflict action:
Wiring conflict action:
Session up action:
Session down action:
Remote loopback action:
Require remote mode:
Require remote MIB retrieval:
Require remote loopback support:
Require remote link monitoring:
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
58
5 22:07:06.870 DST
Purpose
one of the supported commands on the platform in interface
Ethernet OAM configuration mode.
Saves the configuration changes to the running configuration
file and remains within the configuration session.
Ends the configuration session and exits to the EXEC mode.
1s
Y
N
N
N
Active
5
0
1
None
1000
1
None
1000
1
None
60000
1
None
None
Log
Log
Log
Log
Log
Error-Disable
Log
Log
Log
Ignore
N
N
N
Configuring Ethernet OAM