Inquiries - ABB ACS800-U4 Hardware Manual

Check the insulation of the motor and the motor
cable.
If the drive is about to be connected to an IT
(ungrounded) system, check that the drive is not
equipped with EMC filter +E202.
Route the cables.
Install the drive. Connect the power cables. Connect
the control and the auxiliary control cables.
Check the installation.
Commission the drive.
Commission the optional brake chopper (if present).

Inquiries

Address any inquiries about the product to the local ABB representative, quoting the
type code and the serial number of the unit. If the local ABB representative cannot
be contacted, address inquiries to the manufacturing facility.
Task See
Installation: Checking the insulation of the
assembly
The ACS800-04/U4: Type
instructions on how to disconnect the EMC
filtering, contact ABB.
Electrical installation planning:
cables
Installation, Resistor braking
Installation checklist
Appropriate firmware manual
Resistor braking
19
code. For
Routing the
(optional)
About this manual