Before Installation; Delivery Check - ABB ACS800-U4 Hardware Manual

Before installation

Delivery check

The drive module is delivered in a box that also contains:
• output busbars U2, V2 and W2 fastened to the side of the module
• busbars for brake resistor connection if brake chopper is included (at the side of
the module)
• terminals to be connected to the output busbars and PE grounding at the side of
the module (screws in a plastic bag included)
• fastening brackets (2 pcs, one loose and one prefitted to the pedestal)
• motor control and I/O unit (RDCU)
Note: The fibre optic cables and power supply cable to be connected to the RMIO board inside the
RDCU unit are wound on the top of the drive module.
• optional modules (if included) factory installed onto the RMIO board in the RDCU
unit
• residual voltage warning stickers
• hardware manual
• appropriate firmware manuals and guides
• optional module manuals
• delivery documents.
The following items are delivered in separate packages:
• control panel and an 2.5 m (98 in.) cable (if included)
• control panel mounting platform (if included)
• DC busbars (if included).
Check that there are no signs of damage. Before attempting installation and
operation, check the information on the type designation label of the drive to verify
that the unit is of the correct type. The label includes an IEC and NEMA rating, C-UL
US, and CSA markings, a type code and a serial number, which allow individual
recognition of each unit. The first digit of the serial number refers to the
manufacturing plant. The next four digits refer to the unit's manufacturing year and
week respectively. The remaining digits complete the serial number so that there are
no two units with the same serial number.
The type designation label is located on the front cover and the serial number label
inside the unit. Example labels are shown below.
53
Installation