415B Built-In Shower Control - Mira 415 Installation And User Manual

12. Fit the 'O' Seal to the tapered end of the outlet nipple and screw it into the
shower control outlet using a 12mm A/F hexagon wrench (not supplied). This
will leave the flat face for connection of the shower hose.
13. This completes the installation of the Mira 415 for "Rising and falling back inlet
supplies".

415B Built-in shower Control

The built-in shower control incorporates an integral wall mounting bracket assembly
which can be used to install the shower into a solid, dry-lined, stud partition or dry
partition wall structure, shower cubicle or laminated panel. Installers may wish to
consider other options such as fabricating rear supports using wooden noggins,
however, these methods of fixing are beyond the scope of this guide.
'O' Seal
Connector Nipple
20