Mira 415 Installation And User Manual page 15

1.8 Locate the shower control body onto the backplate and secure by tightening,
clockwise, the two recessed grub screws, using the 2.5mm A/F hexagon wrench
(supplied).
Grub Screw
1.9 Release, anti-clockwise, the two grub screws that retain the inlet elbows, using
the 2.5mm A/F hexagon wrench (supplied). Ensure that the 'O' seal is correctly
located on the smaller diameter shoulder of the brass inlet connector, and not
in the 'V' groove.
'O' Seal
1.10 Refit the elbows in the required position, i.e. rising or falling supplies, ensuring
that the grub screws locate into the grub screw socket.
Tighten, clockwise, the grub screws and fit the two concealing caps into the
hexagon recesses.
Concealing Cap
Rising supplies
Shower Control Body
Backplate
Grub Screw Groove
Falling supplies
15
Inlet Elbow