Massage Operation - Champion ASCENT Operating Instructions And Service Manual

Classic series

Hide thumbs

Table Of Contents

Table of Contents

APPENDIX B (continued) – Heated and Heat/Massage Recliners

MASSAGE

BUTTON

TABLE

OPERATING THE HEATER

Refer to previous section for instructions on how to operate the heater in the heat/massage

recliner.

OPERATING MASSAGE

Uncoil the power cord on the back of the chair and plug it into any standard wall outlet. You will

find the massage buttons on the table of the chair. This will typically be the right table (while

seated in the chair) unless other options require it to be on the left side.

NOTE: The heat and massage options can be used independently of each other.

MASSAGE FUNCTION: The massage switch function is controlled by a repetitively

pressing the massage button. The first button push will turn on the massage light and it

will remain on through the button press cycle until the massage system is off.

BUTTON PRESS SEQUENCE

1. Lower Zone, Low Intensity

2. Lower Zone, High Intensity

3. Full Back, Low Intensity

4. Full Back, High Intensity

5. System Off

NOTE: The massage system is set to turn off fifteen (15) minutes after the last button

push. If the patient wishes to continue using the massage simply repeat the above steps.

NOTE: If the lights on the switch are flashing, unplug the chair from the outlet and

check all of the connectors of the heat system. If a connector is unhooked reconnect

it, plug in the power cord, and check the switch again. If all connections appear ok

and the lights still flash, unplug your chair and contact Champion's customer service.

This does not affect the basic functions of the chair.