Heater Operation - Champion ASCENT Operating Instructions And Service Manual

Classic series

Hide thumbs

Table Of Contents

Table of Contents

APPENDIX B (continued) – Heated and Heat/Massage Recliners

The Champion heated recliner continues to have the same patient controlled positioning with the

added benefit of heated pads in the seat and back. The heat/massage recliner has massage

motors built into the back cushion along with the heat system. This allows for additional patient

comfort at the push of a button.

CAUTION: Please make sure all staff involved in the use of the heat chair have

viewed the in-service instruction pages prior to operating the chair. Incorrect use can

damage the chair and void your warranty.

WARNING: Please keep hands and equipment away from moving parts that can

cause pinch points.

WARNING: NEVER service this chair without unplugging the cord from the wall. Do

not put your hands where you cannot see.

POSITIONING THE CHAIR

Please reference previous operation instruction information for all operating instructions for

positioning of the chair. This includes the use of the trendelenburg option if your chair is so

equipped.

OPERATING THE HEATER

Uncoil the power cord on the back of the chair and plug it into any properly grounded standard

wall outlet. You will find the heater power button on the table of the chair. This will typically be

the right table (while seated in the chair) unless other options require it to be on the left side.

Pressing the button the first time will start the heater at high power and all three lights will come

on. At this setting it will take 5-10 minutes to come to full heat with a patient in the chair.

Pressing the button a second time will take the heater to medium power (two lights on) and a

third will take it to low (one light on). To turn the heater off, press the button a fourth time and

all of the lights will be out.

NOTE: The heat system is set to turn off one hour after the last button press. Repeat

the above process to continue use of the heat feature.

NOTE: If the lights on the switch are flashing, unplug the chair from the outlet and

check all of the connectors of the heat system. If a connector is unhooked reconnect

it, plug in the power cord, and check the switch again. If all connections appear ok

and the lights still flash, unplug your chair and contact Champion's customer service.

This does not affect the basic functions of the chair.