Chair Specifications; Receiving New Chairs - Champion ASCENT Operating Instructions And Service Manual

Classic series

Hide thumbs

Table Of Contents

Table of Contents

APPENDIX B (continued) – Heated and Heat/Massage Recliners

Please reference previous chair specification pages for all load and dimensional specifications of

your heat chair. All heat chairs are built to properly handle the specified load for that model chair.

The heater option does not change the size or load capability of that model.

Power Requirements

Input: 100-240 VAC, 1.0 A max, 50-60 Hz

Output: 12 VDC, 3.5 A, 42 W

Average Measured Maximum Temperatures

CAUTION: No items should be placed behind the patient's back or beneath them.

Placing items (pillow, blanket, etc.) in the chair will expose the item to the heat

generated by the system. Unlike the patient's body, certain item may not absorb and

dissipate the generated heat; this may expose the item to temperatures that are

higher than noted here through trapped heat.

the item, and risk of contact with higher temperatures. Damage to the item or your

chair is not covered by your warranty.

NEW HEAT AND HEAT/MASSAGE CHAIR INSPECTION:

Reference earlier section on receiving new chairs, along with the following operation procedures.

WARNING: The heat or heat/massage chair must be plugged into a properly

grounded outlet and must not be modified in any way. If the three (3) blade plug does

not fit your outlet, have one installed that meets your local codes by an electrician.

Consult an electrician if you are unsure that the outlets are properly grounded. Do not

use a three (3) blade plug to a two (2) blade adapter.