505 Task Chair Without Armrests; 506 Task Chair With Adjustable Armrests; Base Assembly; Back Assembly - Champion 505 Owner's Operating And Maintenance Manual

505 TASK CHAIR WITHOUT ARMRESTS

506 TASK CHAIR WITH ADJUSTABLE
ARMRESTS

BASE ASSEMBLY

1. Place the 5-Star Chair Base on a clean, flat surface with wheels down.
2. Push the large end of the Gas Cylinder into the center hole of the 5-Star
Chair Base. Press base and cylinder together firmly to secure (Fig. 1).
*Foot Ring Option – Slide the Foot Ring over the Gas Cylinder and
tighten the Foot Ring Knob (Fig. 2).
3. Install the Chair Seat over the end of the Gas Cylinder. Press Seat and
Cylinder together firmly to secure (Fig. 3).

BACK ASSEMBLY

4. On the bottom of the Seat Plate, remove the Knob and Hardware (Fig. 4
& 7).
5. Slide the Steel Back Support of the Upholstered Back into the
narrow slot on the rear of the Seat Plate and fasten with the Knob and
Hardware (Fig. 5).
6. On the backside of the Upholstered Back, remove the Knob and
Hardware. Insert the threaded stud of the back hinge through the slot on
the Steel Back Support. Reinstall the Knob and Hardware to secure the
Upholstered Back. Adjust the Backrest and Seat Knobs as needed for
individual comfort (Fig. 6).
SEAT, BACK & BASE ASSEMBLY IS COMPLETE.
Page 5 of 13
manual
Document No.: 006350 - Revision: A
FIG. 5
FIG. 3
FIG. 6
FIG. 1
FIG. 2
FIG. 4
FIG. 7