Port Transceiver Information; Adding The Mmu To The Vlan Membership - Lightware UBEX Installation And Network Setup Manual


  
6. Configuration Steps - Netgear M4300-24X24F
6.4.7. Port Transceiver Information
Navigate to the Switching -> Ports -> Port Transceiver submenu. You can check the connection interfaces by
ports.
TIPS AND TRICKS: this table can be used for debugging purpose as well. If you are sure that an SFP+
transceiver module or DAC cable is connected to a port but it is not in the table, might be the module or
the cable has contact problem or it is faulty.
Port Transceiver Information page
Installation and Network Setup Guide for UBEX
6.4.8. Adding the MMU to the VLAN Membership
Once the MMU boots up and available, it is needed to be added to the VLAN membership.
Switchport Configuration
Navigate to the Switching -> VLAN -> Advanced -> VLAN Trunking Configuration submenu. Select the port of the
MMU (e.g. 1/0/46) and set the following values:
Switchport Mode: Trunk
▪
▪ Access VLAN ID: 1
Native VLAN ID: 1
▪
Trunk Allowed VLANs: 1-4093
▪
When it is done, press the Apply button to save the configuration.
VLAN Trunking Configuration page
29