Connecting Steps - Lightware UBEX Installation And Network Setup Manual


  
3. Installation of the UBEX Matrix
3.3. Connecting Steps
4K PC Blu-ray player Monitor
HDMI HDMI HDMI HDMI
MAIN MENU TX
 Ports
EDID
System status
System settings
UBEX transmitter
LAN Power
TX
Touch panel Power
SIDE
UBEX-MMU-X200
RS-232
System controller
4K TV Monitor
HDMI
OPT / DAC OPT / DAC
UBEX receiver
LAN
RX
Laptop
SIDE
B A B A B A B A B A B A B A B A B A B A
L3 switch
MMU
OPT / DAC
SIDE
CATx
LIVE MAIN MENU
POWER
CONTROL System Settings
ETHERNET 1  Input Ports
Output Ports
EDID
Health
Matrix Management Unit Presets
RESET Control USB
UBEX-MMU-X200 Matrix Management Unit
LAN Power
RS-232
Laptop Power
Installation and Network Setup Guide for UBEX
4K projector
OPT
DAC
HDMI
HDMI
HDMI
MAIN MENU RX
 Ports
EDID LAN
System status
System settings
Power
Power
OPT
Power
DAC
HDMI
LAN
Power
OPT / DAC
CATx
LAN
RS-232
RS-232
Power
INFO: Powering on the devices is recommended to do as the final step during the installation.
Transmitter (TX) Side
Connect singlemode or multimode (depends on the installed SFP+ modules) fiber optical
cables or DAC cables between the UBEX transmitter and the Layer 3 (L3) network switch.
Connect the transmitter and the source devices (e.g. 4K PC, Blu-ray player) using the HDMI
input 1 and 2 ports by HDMI cables.
Connect the local sink devices (e.g. monitor, 4K TV) to the HDMI output 1 and 2 ports by HDMI
cables. The output ports are local loopback ports in this case, it means the same streams are
transmitted which are received on the input ports.
Optionally connect the transmitter to a LAN in order to control the device. User Ethernet is
also transmitted over the SFP+ interface so be sure not to create network loop!
Connect the power adaptor to the AC input on the transmitter first, then to the AC power
socket.
Receiver (RX) Side
Connect singlemode or multimode (depends on the installed SFP+ modules) fiber optical
cables or DAC cables between the UBEX receiver and the Layer 3 (L3) network switch.
Connect the sink devices (e.g. monitor, 4K projector) to the HDMI output 1 and 2 ports by
HDMI cables.
Optionally connect the receiver to a LAN in order to control the device. User Ethernet is also
transmitted over the SFP+ interface so be sure not to create network loop!
Connect the power adaptor to the AC input on the receiver first, then to the AC power socket.
Matrix Management Unit (MMU) Side
Connect the MMU and the L3 network switch by an optical cable (via the installed SFP module),
or DAC cable ((via the SFP slot), or CATx cable (via the CATx connector).
Connect a controller device (e.g. laptop) to the MMU with a CATx cable for the connection to
the LAN network or with serial cable via the RS-232 connector.
Optionally connect a third-party system controller with a serial cable via the RS-232 connector.
Connect the power adaptor to the AC input on the MMU first, then to the AC power socket.
11