Igmpv2 Snooping - Lightware UBEX Installation And Network Setup Manual


  
6. Configuration Steps - Netgear M4300-24X24F
VLAN Membership
After that navigate to the Switching -> VLAN -> Advanced -> VLAN Membership submenu. Select the 286 in the
VLAN ID menu.
Set all LAG's to T (Tagged). Also add the port where the control device (e.g. laptop) connects to the switch
for enabling the user Ethernet.
When it is done, press the Apply button to save the configuration.
VLAN Trunking Configuration
Go to the Switching -> VLAN -> Advanced -> VLAN Trunking Configuration submenu. Select all LAGs and set the
Switchport Mode to Trunk. When it is done, press the Apply button to save the configuration.
VLAN Trunking Configuration page
VLAN Membership page
Installation and Network Setup Guide for UBEX
6.4.5. IGMPv2 Snooping
DEFINITION: IGMP snooping is the process of listening to Internet Group Management Protocol network
traffic. The feature allows a network switch to listen in on the IGMP conversation between hosts and
routers.
Configuration
Navigate to the Switching -> Multicast -> IGMP Snooping -> Configuration submenu. Check the settings are
set to the following values:
Admin Mode: Enable
▪
▪ Validate IGMP IP header: Enable
▪ Proxy Querier Mode: Enable
When it is done, press the Update button to save the configuration.
IGMP snooping configuration page
26