Advertisement
FW-7551SE User Manual
In this screen, you can configure the LAN bypass functionality. The system can accommodate one LAN
module.
You can activate or deactivate the LAN Bypass ports. For the description of the physical ports that are
capable of the LAN Bypass function, refer to the Front Panel Feature in Chapter 1 Introduction.
the Ethernet expansion module may support Lanner Generation 2 or
Note:
Generation 3 Bypass depending on the module specification. See appendix D
Programming Generation 2 and 3 LAN Bypass for more information
You can enable or disable the automatic activation of hardware LAN Bypass function in the event of a
power failure. Hardware Bypass can automatically activate to allow network traffic to continue.
The LAN bypass can be turned on or off in two system states, i.e., power on and power off. The following
are the BIOS menu and illustration of the possibilities of LAN bypass configuration in each state. Note that
according to the result from table 2, the ports are not bypassed in both Power-on or Power-off state when
the setting "Power off LAN Bypass for Module 1" is disabled.
Bypass settings in the
System Status
Power on
Power off
BIOS
Runtime LAN Bypass for Module 1
Enabled
Bypass
Bypass
42
Power off LAN Bypass for
Disabled
Non-Bypass
Bypass
Module 1
Enabled
Advertisement
