Advertisement
Chapter 3: Hardware Setup
The system can accommodate one 2.5" Serial-ATA disk. Follow these steps to install a hard disk into the
FW-7551SE:
1. Unscrew the 4 screws on the hard disk tray to take out the hard disk tray from the system.
2. Insert the four rubber washers into the four notches of the tray.
3. Place the hard disk on the tray and align the holes of the hard disk with the mounting holes on the tray.
Secure the hard disk with 4 disk screws on the tray.
4. Connect the Serial-ATA power and data cables to the hard disk's power and drive connector respectively.
5. Plug the Serial-ATA power and data disk cables to the Serial-ATA power and drive connectors on the
main board.
6. Put the hard disk tray with the installed hard disk back to the system and secure it with the mounting
screws.
Align and push the washers
horizontally into the 4 notches.
S
S
A
A
T
T
A
A
P
P
o
o
w
w
e
e
r
r
Note: The HDD kit is not included in the package; please order it separately.
S
S
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
S
A
T
A
C
S
A
T
A
C
A
A
T
T
A
A
C
C
o
o
n
n
n
n
e
e
c
c
t
t
o
o
r
r
33
o
n
t
a
c
t
s
o
n
t
a
c
t
s
Advertisement
