Yamaha Aventage RX-A780 Owner's Manual page 43

5
To start the measurement, press ENTER.
The measurement will start in 10 seconds. Press ENTER to start the
measurement immediately.
The following screen appears on the TV when the measurement finishes.
Warning message (if available)
1
Note
▪ To stop the measurement temporarily, press RETURN.
▪ If any error message or warning message appears, see the following:
– "Error messages from YPAO" (p.46)
– "Warning messages from YPAO" (p.47)
6
Confirm the results displayed on the screen.
Note
To check the measurement results specifically, select "Measurement result" and press ENTER. For
details, see the following:
▪ "Checking the YPAO measurement results" (p.44)
7
Use the cursor keys to select "Save" and press ENTER.
1
The adjusted speaker settings are applied.
Note
To finish the measurement without applying the result, select "Cancel".
8
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Notice
▪ The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be
exposed to direct sunlight or high temperatures (such as on top of AV equipment).
Note
"YPAO Volume" in the "Option" menu is automatically enabled after the YPAO measurement. Then, the high-
and low-frequency levels are automatically adjusted according to the volume so that you can enjoy natural
sounds even at low volume. For details on "YPAO Volume", see the following:
▪ "Adjusting the high- and low-frequency levels automatically according to the volume" (p.94)
43
En