Storage; Maintenance; Belt Or Brushroll: Removal & Replacement - Hoover SteamVac FH50010 Operating, And Servicing Instructions

Placing
2.16
Dirty Water
Tank in Base
of Cleaner
2.15
A
Grasp handle and hook front of dirty water tank
into base of cleaner, making sure front of dirty
water tank is resting on the base (Diagram A). The
Dirty Water Tank has 3 tabs on the underside
which MUST latch into the underside of the base of
the cleaner. It is very important to lift the base of
the cleaner off of the carpeting and hook the noz-
zle to the base so that the nozzle is flush with the
Lift front base of
cleaner off carpeting base of the cleaner (Diagram B). Failure to install
the Dirty Water Tank correctly (Diagram C), will
with one hand.
result in poor dirty water pickup. The Dirty Water
Tank will need to be emptied once or twice per fill
up of the Clean Water Tank.

3. Maintenance

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner
will ensure continued cleaning effectiveness.
Belt or Brushroll: Removal and Replacement
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER
BEFORE CHANGING BELT.
For Belt Style 7 replacements, please call 1-800-263-6376 or visit our website at www.hoover.
com to locate a dealer nearest you.
To Remove Belt
3.1 3.2
Flip cleaner on its side To remove belt cover,
to expose nozzle base. use Phillips screw-
driver to remove the
two screws. Arrows
show location of
screws.
2.17
B
C
While making sure the
front of the dirty
water tank is resting
on the base, place the
rear of the tank into
the base of the clean-
er. Push handle down
until it latches.
NOTE: Do not store
cleaner with solution
in reservoir or dirty
water in dirty water
tank. Mineral deposits
and mildew can form
which will affect the
performance of your
carpet cleaner.
3.3 3.4
Grasp belt cover near Grasp brushroll with
brushroll and lift out. one hand, using other
hand to keep tension
on belt when remov-
ing. Lift up when pull-
ing out.
9