Assembling Cleaner; Carton Contents - Hoover SteamVac FH50010 Operating, And Servicing Instructions

1. Assembling cleaner

Carton contents

Unpack cleaner from carton and identify the
parts shown. Remove and dispose of card-
board packing.
1.1
A
B
C
C
A. Upper Handle
B. Midsection
C. Base
Operate cleaner only at voltage specified on
data plate on back of cleaner.
1.2
Stand base in upright position. Push mid-
section onto base by aligning tabs on the
backside of midsection and the pockets on
the backside of base. Assemble the two (2)
lower handle screws in the following man-
ner: while holding nut in place, insert screw
through front of midsection and tighten.
NOTE: Make sure the power cord is out of
the way to avoid pinching.
1.3
G
Slide upper handle down onto unit. Place
screw into recess in back of upper handle
and tighten.
1.4
Place solution reservoir into cleaner and tilt
back until it snaps into place.
5