Installing The Oven - Miele H6860BPXB Operating And Installation Instructions


The oven must not be operated
until it has been correctly installed in
its housing unit.
The oven must have an adequate
supply of cool air for proper
operation. The required air must not
be heated excessively by other heat
sources, e.g. wood burning stove.
Observe the following when
installing:
Do not fit a back panel in the housing
unit.
Make sure that the shelf that the
oven sits on does not touch the wall.
Do not fit insulation to the side walls
of the housing unit.
Before installation
 Before connecting the appliance to
the mains, you must disconnect the
power supply to the isolator switch or
fused spur connection unit.
Building in
 Connect the mains cable from the
oven to the isolator.
Use the handle recesses at the sides
of the oven for carrying it. It is
advisable to dismantle the door before
installing the oven and to remove any
accessories from the oven interior.
This will make it easier to slide the
oven into the housing unit.
 To remove the door, use the opener
supplied to lever the door open.
Insert the opener into the edge of the
door at an angle in the gap between
the control panel and the door. You

Installing the oven

can also pull the door open by
grasping the sides of the door with
both hands and pulling carefully until
it opens.
 See "Cleaning and care - dismantling
the door" for instructions on how to
take the door off. Remove any
accessories from the oven interior.
 Push the oven into the housing unit
and align it.
 Reconnect the mains power to the
isolator switch.
 Touch the  sensor to open the door
if you have not taken it off already.
 Use the screws supplied to secure
the oven to the side walls of the
housing unit through the holes in the
oven trim.
 Refit the door, if necessary (see
"Cleaning and care - Refitting the
door").
145