Installing/Removing Tailstock Center - Grizzly G0844 Owner's Manual

Installing/Removing
Tailstock Center
The included live center installs into the tailstock
quill with an MT#2 tapered fit.
Items Needed
Leather Glove/Clean Rag .................................. 1
Installing Tailstock Center
1. Loosen quill-lock
handwheel until quill extends about 1", as
shown in Figure 17.
Quill-Lock
Handle
Quill
Figure 17. Installing center into tailstock quill.
2.
Make sure mating surfaces of center and
quill are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3. Firmly insert tapered end of center into
tailstock quill, as shown in Figure 17.
4. Make sure center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out easily.
5. Secure quill in place by retightening quill-lock
handle.
Model G0844 (Mfd. Since 2/18)
Qty
handle, and rotate
Handwheel
Removing Tailstock Center
1.
Loosen quill-lock handle.
2.
Hold a clean rag under spindle or wear a
glove to catch center when you remove it.
3.
Rotate handwheel
tailstock quill will retract back into quill, caus-
ing center to be forced out. If this does not
work, use the knockout tool to remove the
center.
counterclockwise—
-21-