Installing/Removing Headstock Center - Grizzly G0844 Owner's Manual

Installing/Removing
Headstock Center
The included spur center installs in the headstock
spindle with an MT#2 tapered fit.
Items Needed
Leather Glove/Clean Rag .................................. 1
Knockout Rod .................................................... 1
Installing Headstock Center
1. DISCONNECT MACHINE FROM POWER!
2. Make sure mating surfaces of center and
spindle are free of debris and oily substances
before inserting center to ensure a good fit
and reduce runout.
3.
Insert tapered end of center into spindle, and
push it in with a quick, firm motion, as shown
in Figure 15.
Figure 15. Example of installing center in
headstock spindle.
4. Make sure center is securely installed by
attempting to pull it out by hand. A properly
installed center will not pull out easily.
-20-
Removing Headstock Center
1.
DISCONNECT MACHINE FROM POWER!
2.
Hold a clean rag under spindle or wear leath-
er glove to catch center when you remove it.
3.
Insert knockout rod through outboard end of
spindle and firmly tap back of center, catch-
ing it as it falls, as shown in Figure 16.
Qty
Knockout Rod
Figure 16. Example of removing headstock
Spur
Center
center with knockout rod.
Model G0844 (Mfd. Since 2/18)